Shapes
Standard Shapes
The shapes below are UniPunch standards and are available for most hole punching units. When ordering, specify dimensions as required. Refer to individual Unit specifications for size limitations. Intermediate and metric sizes are available at no additional cost.
Custom Shapes
Some of the custom shapes we manufacture are shown below. A code number is provided for easy referencing when ordering. A fully dimensional sketch should accompany all orders or inquiries. For shapes not shown below, consult the UniPunch Quotation Department.
Angular Orientation for Punches and Dies
The Most shaped punches and dies can be used in two positions at 90 degrees to each other. Angularity is measured from 0 to 360 degrees clockwise when viewed from the top. Zero degrees is at the front of the unit. See diagrams below:
